Helping Keep the Workplace Safe PRODUCT DATA SHEET
MICRO-REMLIVE
Part No uRL-1
Micro-Remlive is the latest addition to the range of Remlive Electrical Safety Products. Its purpose is to provide CONFIRMATION OF CORRECT ISOLATION. The Micro is designed to fit through the front of a control panel or switch and occupies a standard 30mm pushbutton hole. It is rated at IP 65 for Europe and NEMA 4X for USA. The front face of the Micro consists of a clear polycarbonate material, behind which are a series of LED's and a legend displaying the following conditions. Phase and Neutral
indication
Indication
of any voltage present between 24v and 600v ac / 24v and 600v dc - including
neutral voltage if present, and stored energy
A safety message
with instructions
Because it
has the format of a pushbutton we have a large legend plate to show additional
information or a more complex safety message.
The Micro contains fully encapsulated,
triple
redundant, electronic circuits and the connection is via a flying lead
which connects to the electrical supply as close as possible to the Isolation
point - i.e. immediately after the disconnect switch.
The concept of operation is that when
the power supply is in the "ON" state then the LED displays on the
face of the micro would be illuminated with some flashing LED's to attract
attention. These LED's would remain operational until all voltage has decayed
to less than 24v on all connections including the Neutral.
So the person performing the isolation
can see that the Micro is functional with the power on and see a positive
change of state after correct isolation, because Micro-Remlive will continue
to give some form of illumination until all voltage connected to it is
below 24 volts
|
